Kyosho GPB104 NSR500 Tank and Rear Cowl Replacement  [KY-GPB104B]

Kyosho GPB104 - Tank & Rear Cowl Set(NSR500)
Price:
NZD$21.18
Brand:
Kyosho
Model:
KY-GPB104B
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $17.76 each $6.84 or 16%
3+ $16.87 each $12.92 or 20%
Write a review

Accurate Replacement for NSR500 Bodywork

The Kyosho GPB104 Tank & Rear Cowl Set fits the NSR500 from the Hang On Rider Series, engineered for a close fit that preserves the model's classic lines and aerodynamic intent.

Maintains Original Styling

Fitting this tank and rear cowl helps the NSR500 keep its intended look and structural balance. It is suitable for display models and hobbyists who ride their kit on scale surfaces.

Compatibility Details

This accessory is made exclusively for Kyosho NSR500 models and installs without trimming. It is ideal for replacing damaged body panels while keeping alignment with existing mounts.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the GPB104 compatible with vintage NSR500 kits?

Compatibility depends on the specific NSR500 release, but the GPB104 was produced for standard Hang On Rider NSR500 variants; check mount points before fitting.

Will fitting this change handling?

No significant handling changes are expected since the set is a cosmetic and structural body replacement rather than a performance mod.

What prep is needed before painting?

Clean the parts, sand lightly with fine grit, then apply a suitable plastic primer before topcoat for best adhesion and finish.

Are replacement fasteners included?

Fasteners are not typically included; reuse the original screws where possible or source small model screws that match the mount points.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved