Kyosho IF218 Joint Cup 4mm L=17 FM185 - Pair for track and bashing  [KY-IF218]

Kyosho IF218 - Joint Cup(4mm/L=17/2pcs/FM185)
Price:
NZD$15.15
Brand:
Kyosho
Model:
KY-IF218
GTIN:
4548565109470
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $12.85 each $4.59 or 15%
3+ $12.22 each $8.79 or 19%
Available in shop
Write a review

Compact joint cup for dependable drivetrain linkages

The Kyosho IF218 Joint Cup provides a reliable interface between driveshaft parts, made to keep rotational motion consistent. Its internal diameter is Φ4mm and length L=17, matching common shaft sizes so it slips into compatible assemblies with minimal fuss.

Suited for club racing and rough-field use

This joint cup is chosen by hobbyists who swap between asphalt circuits and rough paddock runs. The construction stands up to impacts and frequent loading, helping preserve drivetrain geometry during hard use.

Where it fits and when to replace

Install the Kyosho IF218 Joint Cup when the original cups show play or wear. It is a direct solution for restoring tight coupling and keeping your drivetrain running true without complex modifications.

Can I use this joint cup on non-Kyosho models?

Yes, provided the mating shaft and housing dimensions match Φ4mm and L=17. Always verify physical fit rather than relying only on brand names.

Is any preparation needed before fitting?

Clean the area, remove old grease and check for damage on the shaft. A light film of grease will help during assembly and reduce early wear.

What quantity is supplied per pack?

The pack contains two joint cups, suitable for replacing both sides of a single joint assembly or as a spare pair.

How often should I inspect these parts?

Inspect your joints after heavy sessions or if you notice vibration or steering vagueness. Regular checks prevent small issues turning into larger drivetrain faults.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved