Kyosho IF290B Engine Mount Plate for Inferno NEO (t=4.0)  [KY-IF290B]

Kyosho IF290B - Engine Mount Plate(t=4.0/L,R)
Price:
NZD$19.37
Brand:
Kyosho
Model:
KY-IF290B
GTIN:
4548565514502
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $16.37 each $6.00 or 15%
3+ $15.55 each $11.46 or 20%
Write a review

Engine Plate Designed for Inferno NEO Chassis

This Kyosho IF290B engine mount comes as paired left and right halves labeled L and R and specified as t=4.0. It serves as the structural interface between the nitro engine and the chassis on Inferno NEO 3.0 and 4.0 machines, ensuring a stable mounting surface and repeatable alignment during engine replacement or maintenance.

Fitment advice: the plate matches the mounting bolt pattern used on Inferno NEO platforms; retain original fasteners and confirm left/right orientation before final torque. Installation typically requires removal of the top deck and careful positioning of the motor flange to maintain correct spur and pinion engagement with the gearbox.

Service role: swapping the mount plate can restore factory engine placement after impact damage or wear, and it provides a reference point when fine-tuning engine setback and cooling clearances. Follow standard workshop practice when securing hardware and check alignment after a break-in or heavy run.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this plate fit both NEO 3.0 and NEO 4.0?

Yes. The IF290B is produced to align with the original engine mounting layout for both Inferno NEO 3.0 and 4.0 chassis.

Does the t=4.0 affect clearance or tuning?

t=4.0 specifies the plate thickness and can influence engine offset and cooling space. Confirm this thickness matches your setup before final installation.

Best practice to avoid misalignment during fitting?

Start screws by hand to hold pieces in place, align the motor flange to the gearbox, set mesh gently, and then torque screws progressively while checking alignment at each step.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved