Kyosho IF732B Wing Support for Inferno MP11  [KY-IF732B]

MP11 rear wing support details

The Kyosho IF732B wing stay set serves as the replacement rear wing support specifically for the Inferno MP11 chassis, providing the mounting points that hold the rear wing in place. It is intended as a spare to restore proper wing position and alignment on 1/8 scale RC buggies using the MP11 setup.

Compatibility is centred on the MP11 mounting pattern; the stay aligns to the chassis' factory wing posts and installs using the existing fastener locations. When replacing a damaged stay, verify the wing mounts square and that the holes match the chassis to prevent torsional loads that can alter handling.

In tuning terms the wing stay establishes the wing's fixed position and therefore contributes to rear downforce and straight-line stability. Even small variations in stay geometry or clamp pressure can change handling feel, so validate alignment after any setup change before running.

For ongoing care inspect the stay for any deformation or hairline cracks and check hardware torque at intervals. If original screws or spacers are not present, obtain hardware compatible with MP11 mounting points rather than adapting the chassis.

Use the IF732B replacement to preserve correct wing fitment on MP11 vehicles and to support predictable aerodynamic response during setup and repair.