Kyosho IFB021 MP10 0.8mm Race Body Shell  [KY-IFB021]

Kyosho IFB021 - Body (MP10/0.8mm)
Price:
NZD$53.17
Brand:
Kyosho
Model:
KY-IFB021
Condition:
Brand New
Write a review

MP10 Body Upgrade with Kyosho IFB021

Kyosho IFB021 is tailored for the Inferno MP10 lineup and built in 0.8mm to manage toughness while keeping weight down. It is a reliable replacement when original shells show wear or when you need a fresh race setup.

Aerodynamic Profile for Racing

The shell follows the MP10 chassis contours to preserve aerodynamic efficiency and steering response. At 0.8mm the body aims to protect against common track knocks without adding unnecessary mass that affects acceleration.

Where to Use the IFB021

This IFB021 body is compatible with the Kyosho Inferno MP10 series, including MP10T, and is suitable for both practice sessions and competitive heats. Its precise cut lines make installation and trimming straightforward for most drivers.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
Yes, the IFB021 is designed to fit the MP10 family and is compatible with MP10T variants, though you should check alignment and trim where necessary.
Most installations use the stock body posts and mounting hardware; minor trimming may be required for a perfect fit on some setups.
0.8mm offers reasonable resistance to typical track impacts, but frequent heavy hits will wear any thin shell faster than thicker alternatives.
Bodies of this type are usually supplied unpainted so you can mask and use polycarbonate paints for a custom finish that matches your team colours.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved