Kyosho Inferno MP7.5 Front and Rear Titanium Cap Joint TMP75042 by GPM  [TMP75042]

Titanium cap joint for MP7.5 gearbox service

This pair of titanium cap joints is supplied for the Kyosho Inferno MP7.5 and is intended to replace the original cap joint at both front and rear gearbox mounts. Each piece interfaces the driveshaft to the gearbox cap, preserving alignment and transmitting torque through the drivetrain.

Installation follows normal gearbox servicing steps: remove the cover, take out the stock cap joint, install the titanium unit in the correct orientation and reassemble while confirming correct gear mesh and bearing placement. Use appropriate hex keys and avoid over-tightening to prevent component distortion.

Consider this a targeted upgrade: the titanium component improves joint durability and keeps geometry consistent during tuning and track use, supporting predictable drivetrain response without altering suspension or motor setup.