Kyosho IFW709 Engine Mount Plate for Inferno MP11  [KY-IFW709]

Engine mounting plate tailored to the MP11 chassis

This one-piece engine mount plate is an RC-scale replacement created for use with Kyosho Inferno MP11 series cars. As a direct-fit spare it replaces the chassis engine mounting interface and brings back the factory single-piece mounting geometry for MP11 layouts.

It plays a simple but important role in vehicle setup by defining engine location and alignment and setting the reference for exhaust and clutch linkages. Installation typically involves removing the original mount and refitting the chassis' existing hardware and mounting points, so servo, ESC, and gearbox locations remain unchanged.

When tuning, this component offers a steady reference point for adjusting engine offset and centreline during clutch and pipe adjustments. By maintaining factory alignment it helps hobbyists and shops measure the effect of aftermarket changes without altering other drivetrain and suspension settings.

Compatibility

Compatible with Inferno MP11 chassis that use a single-piece engine mount; confirm your chassis code to ensure an MP11 layout before purchase.

Apply thread-lock where recommended, check screw condition and chassis locating tabs during fitment, and keep the mount clean to preserve accurate engine placement.