Kyosho LA419-01 67 Swing Shaft for LAZER ZX7.5 (Single Piece)  [KY-LA419-01]

Kyosho LA419-01 - Swing Shaft(67/1pc/ZX7.5)
Price:
NZD$17.93
Brand:
Kyosho
Model:
KY-LA419-01
GTIN:
4548565524228
Condition:
Brand New
Write a review

Spare swing shaft suited to LAZER ZX7.5

The Kyosho LA419-01 swing shaft serves as a replacement component intended for LAZER ZX7.5 chassis maintenance and setup. It is supplied as one item marked with the "67" designation and is used to re-establish correct swing geometry on the listed model.

Replace the shaft when signs of wear appear on the swing link or during scheduled teardown and rebuild. Source details describe the item by model code and fit rather than by material, so inspect the "67" sizing against your existing shaft before committing to fitment.

Fitting advice: remove nearby linkages for access, check alignment during assembly, confirm there is no excessive runout or side play, and re-secure any bearings or fasteners that interface with the shaft. This product is intended for model-scale RC use only.

Compatibility

Compatible with LAZER ZX7.5 as denoted in the product information.

A straightforward direct-replacement swing shaft for regular repairs and setup of LAZER ZX7.5 vehicles.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What material is this shaft made from?

The original listing identifies the part by code and fitment only; material is not specified, so inspect the delivered unit or request material details from the seller if material properties are critical.

Is this suitable for high-stress or competitive use?

Durability depends on the part material and your running conditions; because the source does not list material, evaluate the component visually and during a cautious test run before competitive use.

Can I inspect the "67" sizing before I fit it?

Yes. Compare the part marking and measure the shaft to confirm it matches the "67" reference on your original component before installation.

Any checks to extend service life after fitting?

Regularly inspect for wear, ensure bearings and fasteners remain secure, and address any play or corrosion quickly to prolong component life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved