Kyosho MB010 Replacement Gear Set for Mini-Z Buggy MB-010  [KY-MB010]

Kyosho MB010 - Servo Gear Set
Price:
NZD$9.01
Brand:
Kyosho
Model:
KY-MB010
GTIN:
4548565193295
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $8.20 each $1.60 or 9%
3+ $7.79 each $3.64 or 13%
Write a review

Mini-Z Buggy steering gear spare

This Kyosho MB010 servo gear set is supplied as a direct replacement choice for Mini-Z Buggy MB-010 radio-controlled models, described here as an aftermarket RC accessory. The description emphasises which models it suits, the function of the gears inside the steering servo, and practical swap guidance without making extra technical claims.

The component functions as a spare for the internal servo gear train used in Mini-Z Buggy steering units. If your steering servo shows excessive play, intermittent clicking, or fails to centre reliably, renewing the internal gears can return predictable steering behaviour. The focus remains on fitment and service role rather than detailing materials or gear tooth counts.

Fitting tips: these gears replace the existing servo gear stack on the Mini-Z Buggy MB-010 chassis. Check mesh and alignment during installation, set neutral centring before reconnecting linkages, and bench-test the servo through its full range at low input to ensure smooth operation before running the car.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this the correct spare for MB-010 Mini-Z buggies?

Yes. This set is intended as a replacement for the steering servo gear train used on Mini-Z Buggy MB-010 series vehicles.

Will swapping gears fix servo noise and slop?

In many cases worn or damaged internal gears are the cause of noise and slop; replacing them typically reduces those symptoms when the new gears are correctly meshed and set up.

Any final setup recommendations?

After installation, verify neutral centring, adjust gear mesh to avoid binding, and operate the servo slowly through its range to confirm consistent movement before track use.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved