Kyosho MB026 Mini-Z MB-010 Replacement Pillow Ball M2 (Pack of 8)  [KY-MB026]

Kyosho MB026 - ?4.8 Pillow Ball(M2/8pcs)
Price:
NZD$0.00
Brand:
Kyosho
Model:
KY-MB026
GTIN:
4548565497713
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Compact Pillow Ball for Mini-Z MB-010

The Kyosho MB026 pillow ball serves as a drop-in replacement for Mini-Z MB-010 linkages and small steering joints, listed with M2 thread sizing and packaged as eight pieces for maintenance or refresh tasks.

As a ball-socket type connector, the pillow ball locates small linkage pins while permitting articulation needed for steering and tie-rod movement. It is commonly used where a low-profile joint is required to keep geometry consistent on a Mini-Z MB-010 chassis.

When fitting, make sure the M2 threads engage smoothly and the ball seats properly in the cup. Replace sets when wear is evident on multiple joints, and verify free motion after installation to avoid binding.

Packing

  • Contents: 8 pcs pillow balls, M2 thread as indicated in product name

Are these compatible with other Mini-Z variants?

They are specified for Mini-Z MB-010 linkage points featuring M2 threads. Compatibility with other Mini-Z models depends on those models using the same ball cup dimensions and M2 threaded posts.

What is the pack quantity?

The product is supplied as an eight-piece set, denoted in the name as (M2/8pcs).

How should I check fit before final assembly?

Thread one pillow ball onto an M2 post by hand to check thread alignment, ensure seating in the ball cup, and confirm the joint moves freely through its intended range before tightening fully.

When is it best to replace pillow balls?

Replace them if you notice play in steering, irregular linkage movement, or visual wear on mating surfaces; changing matching joints at the same time helps keep consistent geometry.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved