Kyosho MBW001 Replacement Slipper Cam for Mini-Z MB-010 3pcs  [KY-MBW001]

Kyosho MBW001 - Setting Cluth Cam(3pcs)
Price:
NZD$0.00
Brand:
Kyosho
Model:
KY-MBW001
GTIN:
4548565198221
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Mini-Z MB-010 Replacement Slipper Cam

The Kyosho MBW001 slipper clutch cam is an aftermarket replacement part designed for Mini-Z MB-010 slipper assemblies. It provides the cam geometry that determines slipper pack compression and slip characteristics without needing major drivetrain changes.

Fitting is simple for model owners who know Mini-Z slipper layouts; the cam installs inside the slipper unit where it meets the pressure plate and springs. Follow the model service manual or factory instructions, check alignment and clearances after installation, and run bench tests prior to driving.

For setup work, adjust the cam in small steps to observe incremental changes in launch and traction. This component is for scale RC application only and should be used as part of a holistic slipper tuning process along with spring preload and friction pad tuning.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the MBW001 a direct swap into MB-010 slipper units?

Yes, the Kyosho MBW001 is intended as a replacement cam for the Mini-Z MB-010 slipper assembly, but confirm fit against your model's service notes before final installation.

What tools are recommended for fitting this cam?

Basic model tools such as small screwdrivers, hex drivers for slipper hardware, and a bench vise or holder to stabilise the gearbox are useful when replacing the cam.

How should I confirm clearance after fitting?

Rotate the drivetrain by hand, check for binding or excess free play, verify the pressure plate sits evenly, and then perform a controlled bench run to validate engagement before track use.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved