Kyosho MBW025G-0 Mini-Z MB-010 Rear Suspension Mount (Adjustable 0 to +3)  [KY-MBW025G-0]

Kyosho MBW025G-0 - Aluminum Rear Suspension Mount (0-deg/Gold)
Price:
NZD$16.91
Brand:
Kyosho
Model:
KY-MBW025G-0
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision aluminium rear mount for Mini-Z MB-010

The Kyosho MBW025G-0 is a machined aluminium rear suspension mount built for the Mini-Z MB-010 chassis. It replaces the original rear mount and is intended to increase durability over the standard plastic fitting.

This MBW025G-0 component offers rear toe adjustment from 0 up to +3 degrees, allowing you to tune rear traction and corner behaviour. Small toe increments can noticeably influence turn-in and stability, so tune progressively and record changes for repeatability.

Fitting is simple: use the existing MB-010 rear mounting points and the current hardware, then verify alignment once fasteners are tightened. Check for any contact with nearby suspension parts and carry out routine inspections of the aluminium surfaces after initial track sessions.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I tune toe for different track surfaces?

Yes. Adjusting toe toward slight toe-in can add rear stability on loose or high-power sections, while a reduced toe setting may help turn-in on tighter layouts. Make changes in small steps and test before finalising settings.

Does the MBW025G-0 replace the stock rear mount completely?

The MBW025G-0 is intended as a direct replacement for the stock rear mount on the Mini-Z MB-010. Confirm that your chassis uses the standard MB-010 mounting pattern before fitting.

Are any special parts or tools needed?

No special parts are required; use the existing MB-010 rear mounting hardware and standard RC tools for installation. After the first run, recheck fasteners and alignment.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved