Kyosho Mini Inferno 15-Tooth Delrin Motor Gear DMIF015T by GPM  [DMIF015T]

Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T
Price:
NZD$2.57
Brand:
GPM
Model:
DMIF015T
GTIN:
4894538045147
Condition:
Brand New
Write a review
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"
alt="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T" title="Kyosho Mini Inferno Delrin Motor Gear (15T) - 1pc set - GPM DMIF015T"

Delrin 15-tooth motor gear for Mini Inferno

The DMIF015T is an aftermarket 15-tooth Delrin motor gear designed for Kyosho Mini Inferno models. It functions as a direct-pinon replacement and allows small changes to gearing to tune throttle response and top speed tradeoffs.

Delrin construction keeps running friction low and dimensions stable during normal RC use, making it compatible with typical brushed and brushless motor choices in Mini Inferno kits. During fitment, check for correct axial alignment and optimal gear mesh, secure the set screw, then rotate the drive train by hand to ensure smooth movement.

Swap this pinion as part of routine upkeep or when testing gear ratios: try adjacent tooth counts to find the best balance, use a thin shim to fine-tune mesh, and re-inspect after a short test run. This item is intended as an aftermarket RC accessory only.

Is the DMIF015T a direct replacement?

Yes, it is made to replace the motor pinion on Mini Inferno models, but confirm shaft size and set screw location first.

Can I use it with brushless motors?

The Delrin pinion works with both brushed and many brushless motors common in Mini Inferno setups; always check mesh and temperature during initial runs.

How do I check gear mesh?

Fit the pinion, mesh with the spur using a thin shim or a piece of paper, tighten the motor mount, then rotate to ensure smooth engagement without binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved