Kyosho Mini Inferno 47mm Aluminium Main Shaft MIF1237 by GPM  [MIF1237]

Kyosho Mini Inferno Alloy Main Shaft (47mm) - 1pr - GPM MIF1237
Price:
NZD$5.48
Brand:
GPM
Model:
MIF1237
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision 47mm aluminium main shaft for Mini Inferno

This replacement main shaft suits Kyosho Mini Inferno models and is produced from aluminium alloy at a 47mm length to restore correct drivetrain geometry and offer a tougher alternative to worn stock shafts.

Fit and installation: the component is designed to work with standard Mini Inferno gearbox assemblies without modification in most cases. Access requires gearbox disassembly; reinstall using correct bearing seating and torque settings and ensure retaining hardware is correctly fitted for alignment.

Tuning and service: an aluminium main shaft is chosen for durability and consistent mesh rather than outright performance gain. Check for shaft runout and inspect bearings during refit to reduce the risk of vibration or premature wear.

Is special preparation required before fitting?

Clean mating faces and confirm bearing fit; the part is made for standard layouts but a quick mock-up check is recommended before final assembly.

Will this change gear mesh settings?

It should not alter nominal gear mesh if bearings and spacers are fitted correctly, but recheck mesh after installation as part of setup routine.

Can I reuse my existing bearings?

You can reuse bearings if they are within tolerance, but replacing worn bearings is recommended to maintain alignment and longevity.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved