Kyosho Mini Inferno Compatible Front Upper Arm MIF-034/BU by 3Racing  [MIF-034/BU]

Upper arm for Kyosho Mini Inferno front end

This blue front upper suspension arm is intended as a direct swap or upgrade for Kyosho Mini Inferno ACME NB16 Racing models. It is designed specifically for the model's front suspension layout and not for any full-size application.

Use this arm when renewing a worn part or when changing suspension geometry during setup. The arm sets the hub carrier position relative to shocks and steering components, so its characteristics influence camber and initial turn-in.

Setup and installation pointers

• Verify smooth movement at the arm pivots and check for any interference before final assembly.
• Unless the chassis manual specifies, keep original bushings and hinge pins to preserve intended alignment.
• Change one parameter at a time and note the effect on handling to develop a reliable setup log.
• Match driver bits to the hex screws and tighten to recommended torque values to avoid crushing pivot points.