Kyosho Mini Inferno Front Arm MIF-033/BU - blue finish by 3Racing  [MIF-033/BU]

Mini Inferno front arm specification

This front suspension arm is produced as an RC-scale component for the Kyosho Mini Inferno platform. It is intended as a like-for-like replacement to recover factory steering geometry and suspension travel after damage or wear.

Fitting is straightforward for anyone used to Mini Inferno maintenance: take off the wheel and hub assembly, free the existing arm from the hub carrier and chassis mount points, then refit the new arm using the original screws and pins. No special modifications are required.

In tuning terms, the front arm controls hub offset, caster and toe link positions, so it has a direct effect on initial turn-in and corner balance. Install this part to reinstate baseline geometry or to ensure consistent chassis behaviour between runs.

Maintain the arm by checking pivot holes and pins for play, tightening hardware to the correct feel, and replacing worn items when needed. The distinct colour helps track which arms are replacements during quick prep checks.