Kyosho Mini Inferno Front Arm Plate Aluminium Upgrade MIF009F by GPM  [MIF009F]

Kyosho Mini Inferno ST /Mini Inferno 09 Alloy Front Arm Plate For Rear Gear Box - 1pc - GPM MIF009F
Price:
NZD$2.57
Brand:
GPM
Model:
MIF009F
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Aluminium front arm plate for Mini Inferno chassis

This aluminium front arm plate is designed to fit the Kyosho Mini Inferno ST and Mini Inferno 09 where the front arm interfaces with the rear gearbox area. It is intended as a direct replacement that lines up with the original mounting points and accepts the same steering and suspension linkages.

Fitting is a simple swap using the stock screw positions; use routine RC maintenance tools and check alignment before final tightening. Gradually tighten screws to your normal torque to prevent stripping or stressing the alloy around the holes.

In tuning terms the plate gives a firmer mounting platform that helps keep arm geometry consistent during use, making it useful for repeatable setup changes or replacing a worn plastic part to recover predictable steering and suspension action.

Does this require chassis modification?

No chassis modification is expected. The plate is made to match the stock screw pattern so it should bolt in directly on compatible Mini Inferno ST and 09 frames.

How should I torque the screws?

Start with finger-tight fitting to confirm alignment, then increase torque in stages to your typical setting. Avoid over-tightening to protect threads in the chassis.

Is this suitable for track tuning?

Yes, the alloy plate gives a consistent mounting point useful for setup tuning where repeatable arm geometry matters, though it is primarily a replacement component rather than a radical performance upgrade.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved