Kyosho Mini Inferno NB16 Titanium Front Upper Arm MIF-034/TI by 3Racing  [MIF-034/TI]

Kyosho Mini Inferno ACME NB16 Racing /Kyosho Mini Inferno Front Upper Suspension Arm - Titanium Color - 3RACING MIF-034/TI
Price:
NZD$14.91
Brand:
3Racing
Model:
MIF-034/TI
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Upper arm role and benefits

The 3Racing MIF-034/TI front upper suspension arm is intended for Kyosho Mini Inferno NB16 vehicles and features a titanium-colour finish. It serves as an aftermarket replacement or upgrade to help dial in front-end behaviour.

Why it matters: the upper arm locates the top of the front link assembly and has a direct influence on roll centre and camber change during travel, which in turn affects turn-in and mid-corner feel. Swap these in when you need repeatable geometry for tuning trials or to replace damaged plastic components.

Installation pointers: this part matches the Mini Inferno NB16 pattern referenced in the product name. Verify hinge pin and ball stud clearances and fit one side first to preserve baseline alignment. Confirm steering sweep and suspension travel before full reassembly. The product listing does not state any required chassis modification.

Can I fit this without changing other parts?

Yes, it is offered as a direct fit for Mini Inferno NB16 geometry, but always double check fastener lengths and ball stud positions for interference.

Will this change handling dramatically?

As a like-for-like arm, handling changes are subtle and depend on setup; it provides a stable mounting point for tuning, not a radical handling overhaul.

How should I check alignment after install?

Set the car on level ground, measure camber and toe at ride height, run a short test and then recheck fasteners and clearances once parts have seated.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved