Kyosho Mini Inferno Rear Damper Mount Plate Graphite GMIF030 by GPM  [GMIF030]

Graphite rear mount plate

This graphite rear damper plate serves as a direct-style replacement for Kyosho Mini Inferno and Mini Inferno 09 models and is supplied as a single unit with the correct screws and lock nuts. It acts as the mounting interface for rear shock assemblies and preserves alignment between the shock tower and chassis when you alter setup.

Why graphite: the plate uses graphite to combine low mass and good stiffness, making it suitable for small-scale track or club use. This component is intended for model suspension tuning only.

Compatibility check: specifically profiled for the Mini Inferno / Mini Inferno 09 shock hole layout; double-check hole spacing on your current tower to guarantee fit before committing to installation.

Installation guide: remove the original plate and screws, position the graphite plate over the tower holes, then secure with supplied hardware. Begin bolts by hand and tighten stepwise to prevent shifting. Use the correct hex driver and verify lock nut security after initial testing runs.

Handling impact: fitting a graphite plate will subtly change flex at the rear shock mount and may influence traction and rotation; tune oil, springs, and mounting positions together to reach the desired balance.