Kyosho Mini Inferno Rear Gear Box Front Arm Plate GMIF009BF by GPM  [GMIF009BF]

This aftermarket front arm plate is produced to fit Kyosho Mini Inferno ST, Mini Inferno and Mini Inferno 09 chassis as a direct replacement to support the rear gear box mounting area. The part comes in a blue graphite finish and is intended where the chassis layout and rear gear box clearance match the listed Mini Inferno variants.

Purpose and benefits: the plate ties the front arm mounts into the rear gear box section, helping to keep suspension geometry stable under load and delivering a stiffer interface than many stock plastic pieces. It is helpful when changing roll centre settings or installing heavier upgrades that need a stronger mounting point.

Fitting notes: prepare basic RC tools, remove the existing front arm plate and hardware, check alignment with the rear gear box mounts, then secure the graphite plate using OEM screws or suitable hex fasteners. Inspect driveline and suspension clearance after fitting. The package includes 1 pcs of the plate in blue graphite.

Tuning advice: confirm exact fit for your Mini Inferno variant before final assembly, check mating surfaces for sharp edges, and use low-strength threadlocker on metal screws if you do not expect frequent disassembly. The component is for RC use only.