Kyosho Mini Inferno Rear Linkage Shaft Half8 MIF-022/BU by 3Racing  [MIF-022/BU]

Mini Inferno Half8 rear swing axle

This rear swing axle is offered as a single pair for Kyosho Mini Inferno Half8 cars and references model MIF-022/BU. It functions as a direct swap for the rear swing linkage and is intended for standard RC suspension service and setup adjustments.

Use the shaft to recover correct suspension geometry or to replace a fatigued rear linkage during routine upkeep. The part interfaces with the rear hub and suspension arm, so confirm the Half8 rear layout on your vehicle before fitting. This is supplied for maintenance and repair use rather than to claim performance gains.

Installation advice: remove the rear hub unit and check bearings and mounting points for wear before installing the new shaft, then verify smooth rotation and correct alignment and fasten to the manufacturer recommended torque values.