Kyosho Mini Inferno ST 2 Degree Rear Holder for Camber and Toe MIF-027/BU by 3Racing  [MIF-027/BU]

Tuning rear suspension on the Mini Inferno ST

This component is an aftermarket rear suspension holder created for the Kyosho Mini Inferno ST chassis and identified as part MIF-027/BU. The 2 degree offset at the mounting point gives a modest rear-arm bias that shifts camber and toe behaviour while leaving the remaining suspension geometry intact.

Fitment and role: designed to replace the OEM rear holder to modify rear wheel alignment for setup tuning. Suited to drivers who run Mini Inferno STs on carpet or outdoor tracks and want fine adjustments to cornering balance and traction. It is intended as a focused tuning option rather than a broad overhaul.

Installation notes: confirm clearance with the rear hub and linkages before final torque and re-check alignment after fitment. Make incremental changes to shock position and toe links during handling tests so you can return to the original setup if required. Ensure full suspension travel is free of bind once installed.

Tuning guidance: select the 2 degree holder for small but measurable rear geometry shifts—likely to affect turn-in feel and rear grip. Combine with targeted shock and tyre changes, altering only one variable at a time and recording results for consistent setup development.