Kyosho Mini Inferno ST Glass Fibre Front Arm Brace GLFMIF008F for Front Gear Box by GPM  [GLFMIF008F]

Front arm plate for Kyosho Mini Inferno ST applications

This single-piece glass fibre front arm plate fits the Kyosho Mini Inferno ST where the front gearbox requires a fibre backing plate. It is intended for scale RC repair, routine replacement and small setup changes on the Mini Inferno ST chassis.

Functionally the plate secures the arm pivot area around the front gear box to preserve suspension geometry and pivot alignment. As a glass fibre component it delivers steadier stiffness than many stock plastics while remaining within RC-scale expectations.

When installing check the plate orientation and that mating surfaces are clean to avoid misalignment. Confirm fastener condition and thread engagement so the arm pivots keep correct clearance. The design keeps stock mounting locations for straightforward replacement.

Use the plate as a wear item or a tuning variable: replacing a damaged plate restores geometry, and swapping to a different stiffness option can produce small changes in front-end response during setup trials. Log any changes so handling differences are trackable.