Kyosho Mini Inferno ST Rear Geometry Holder 1 Deg - MIF-026/BU by 3Racing  [MIF-026/BU]

1 degree rear holder for Mini Inferno range

The MIF-026/BU rear suspension holder is an upgrade-style replacement formed for Kyosho Mini Inferno and Mini Inferno ST cars. It introduces a fixed 1 degree rear offset to assist in small-step setup refinements.

Use this blue holder when you want a no-fuss single-angle change to adjust rear balance. It mounts to the stock rear suspension location and uses existing attachment points for straightforward installation.

Installation notes: remove the original component, fit this holder with the chassis standard fasteners, check clearances and alignment before running, and verify hardware tightness after a short break-in run.