Kyosho Mini Inferno / Mini Inferno ST Rear Suspension 1 Degree Block MIF-026/TI by 3Racing  [MIF-026/TI]

Rear holder brief

The MIF-026/TI rear suspension holder is a compact replacement made to fit Kyosho Mini Inferno and Mini Inferno ST chassis and provides a one degree rear offset for toe tuning. Finished in a titanium colour, the part is intended for incremental setup refinement rather than radical chassis modification.

Its purpose is to nudge the rear geometry to alter toe angle, helping drivers tune corner entry and mid-corner stability on micro on-road surfaces like carpet and smooth asphalt. It installs at the stock Mini Inferno mounting points and functions as a direct replacement component.

Installation is straightforward: remove the existing rear holder hardware, fit the MIF-026/TI holder using the factory bolts, verify threads and alignment, then perform a tracking check before running. Reassess ride height and toe after a short test run and make small adjustments as needed.

Tuning advice: a 1 degree change gives a gentle effect; expect minor differences in rear grip and rotation rather than big handling swings. This holder suits situations where modest toe correction is needed to tidy up balance.