Kyosho Mini-Z AWD Alloy Front Knuckle Arm 1.0mm MZA031F/010G by GPM  [MZA031F/010G]

Front knuckle arm mount suited to Mini-Z AWD

This aftermarket alloy front knuckle arm holder is supplied as a 1pc replacement with mounting screws and is intended for use on Kyosho Mini-Z AWD cars. It replaces the plastic steering arm mount to give a stiffer metal connection between the hub carrier and steering link, reducing deformation under load and producing steadier steering feedback while fine-tuning handling.

Best used on Mini-Z AWD platforms where front-end rigidity and precise steering response are being tuned. The 1.0mm thickness offers a compromise between added chassis stiffness and keeping mass low, making it a good option for drivers wanting firmer steering without major setup changes.

Fitment note: the holder comes with screws and installs in place of the original part. Check thread fit and hardware tightness after initial running and during setup changes to maintain consistent steering behaviour. Treat the component as an alloy spare for scale RC tuning.