KYOSHO Mini-Z AWD Delrin Rear Wide Ridge Wheel DMZA601RW+1.0 by GPM  [DMZA601RW+1.0]

Mini-z AWD Delrin Rear Wide Ridge Rims (6p, 1.0mm Off set , Width 11mm) - 1pr - GPM DMZA601RW+1.0
Price:
NZD$11.65
Brand:
GPM
Model:
DMZA601RW+1.0
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Rear wide ridge wheel for Mini-Z AWD

This rear wheel is specified for KYOSHO Mini-Z AWD cars and carries the model number DMZA601RW+1.0. Manufactured in Delrin, it features a six-point mounting interface, a 1.0mm offset and an 11mm rim width to align with Mini-Z AWD fitment.

Installation requires removal of the original rim assembly, aligning the six-point hub, then securing with existing hardware. Once mounted, inspect tyre clearance around the body and suspension to prevent rubbing during full travel.

In practice this wide rear ridge rim shifts the rear track and alters tyre contact behaviour, useful when dialling rear bite on carpet or small-scale tracks. Adjust handling in small steps and keep tyre compound and pressure consistent for accurate comparisons.

Does this fit MR-03 AWD models?

Yes, it is designed for Mini-Z AWD platforms such as MR-03 AWD, provided the six-point rear hub and axle spacing match. Confirm fitment before final assembly.

Are any special tools required to fit the rim?

No special tools are needed beyond basic Mini-Z screwdrivers and pliers; use the original mounting screws and ensure they are snug but not over-torqued.

Should I change springs or camber when using these rims?

Not necessarily, but because the rear track and contact patch change, you may need small suspension tweaks to restore balance. Make one change at a time and log results.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved