KYOSHO Mini-Z AWD Sinkage Alloy Wheels 3.5mm Offset MZA503F/R/+3.5 by GPM  [MZA503F/R/+3.5]

Mini-z AWD Alloy Front/Rear Sinkage Rims (5p, 3.5mm Off set , Width 8.5mm) - 1pr - GPM MZA503F/R/+3.5
Price:
NZD$10.01
Brand:
GPM
Model:
MZA503F/R/+3.5
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Alloy Sinkage Wheels for Mini-Z AWD

This pair of alloy sinkage rims is crafted for KYOSHO Mini-Z AWD cars as a straightforward wheel upgrade for scale running. The design emphasises precise fit and clearance so you can fine tune ride height and tyre seating without changing hub spacing or driveshaft angles.

The specification in the title summarises the core features: 5p bolt pattern, 3.5mm offset and an 8.5mm nominal width, made in aluminium alloy for consistent fit. These rims are ideal when altering scrub, stance, or swapping tyre profiles and work with standard Mini-Z AWD wheel nuts and typical MR-03 AWD hex adapters.

Fitting advice: remove the factory wheel, confirm hex adapter alignment and surrounding suspension clearance, mount the rim and hand-tighten the wheel nut before a final torque. After fitting, roll the car to check tyre seating and steering travel, and inspect for any rubbing at full lock.

Do these work with stock Mini-Z AWD hex adapters?

They are compatible with the common hex adapters used on many Mini-Z AWD setups, but check adapter thickness and hex retention before locking the wheel down.

What is the material and finish?

Rims are machined in aluminium alloy to offer steady fit and repeatable clearance, suitable for both show and track use.

How do I check clearance after fitting?

With the car on stands, cycle the suspension and steer to full lock, then observe tyre-to-body and tyre-to-suspension gaps and adjust wheel offset or body mounts if needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved