KYOSHO Mini-Z F1 Front Toe In/Out Linkage 0 Deg MKF-02/0 by 3Racing  [MKF-02/0]

Overview of front toe linkage for Mini-Z F1

This is a scale front toe in/out linkage made for KYOSHO Mini-Z F1 chassis and supplied as the MKF-02/0 replacement unit. It provides a fixed 0 degree toe at the front to establish a neutral starting point for steering geometry during tuning or track setup.

Compatibility covers Mini-Z F1 variants that use the matching front linkage mount style used on KYOSHO Mini-Z F1 models. Use it as a direct-fit spare or as an alternative to the original linkage when a 0 degree reference is needed for handling tests or incremental setup work.

Installation notes: remove the existing front linkage in line with the chassis instructions, inspect steering posts and ball studs for wear, and fasten the linkage with the original hardware. Adjust toe via the chassis adjusters or by swapping tie rods to different lengths, keeping both sides symmetric to prevent binding.

Setup notes: a 0 degree front linkage gives a neutral steering baseline, helping you isolate suspension and roll changes without toe-induced handling bias. Try other linkage angles to evaluate toe-in or toe-out effects on turn-in and mid-corner stability.

As a spare part, this linkage is handy for resets, spare inventories, and repeatable tuning sessions on Mini-Z F1 chassis with the standard KYOSHO front mount.