Kyosho Mini-Z MR-015 Graphite Chassis Plate 3Racing KZ-14/2/SG for Ferrari 360 GTC [KZ-14/2/SG]

Kyosho Mini-Z MR-015 Graphite Reinforced Plate For Mini-Z Car Body (Ferrari 360 GTC) - 3Racing KZ-14/2/SG

Price:

NZD$8.67

Brand:

3Racing

Model:

KZ-14/2/SG

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Reduce Flex on Your Mini-Z MR-015 with Graphite

The 3Racing graphite reinforced plate is tailored for Kyosho Mini-Z MR-015 bodies, specifically the Ferrari 360 GTC shell, to add stiffness where it counts. This upgrade is aimed at racers and club drivers who want steadier handling without complex mods.

Benefits of the Graphite Reinforcement

Enhanced Durability: Graphite resists repeated stress from race use and helps prevent cracks in the body mounting areas.
Improved Stability: By bracing the shell, the plate helps keep the body form stable during cornering and launches.
Precision Fit: Engineered to match the Mini-Z MR-015 chassis geometry, so fitting is straightforward for experienced hobbyists.

Quick Installation Advice

Align the plate to the Kyosho Mini-Z MR-015 mounting points and tighten screws in a cross pattern to avoid uneven load. Inspect fasteners after several runs, especially if you race on rough surfaces.

Is trimming the body shell needed?

Most Ferrari 360 GTC shells designed for the MR-015 will accept this plate without trimming, but some third-party shells may require minor trimming around mounting points.

Will weight increase be noticeable?

Graphite adds a small amount of weight compared with thin plastic reinforcements, but the stiffness gain usually outweighs any marginal increase in mass for handling performance.

Can I use standard MR-015 screws?

Yes, the original MR-015 fasteners are typically suitable. If the shell material is thin, consider using small washers to spread the load.