Kyosho Motor Cycle Machined 6-Spoke Rear Wheel KM628/6R by GPM  [KM628/6R]

Precision machined six-spoke rear wheel

A single-piece RC aluminium rear wheel made for Kyosho motorcycle hubs, supplied as 1pc. The six-spoke design offers a metal replacement ideal for scale builds and racing models where dimensional accuracy matters more than economy plastics.

The wheel is intended as a direct replacement when hub geometry and mounting patterns match the Kyosho motorcycle hub. It provides consistent runout and a hard mounting surface that helps during balance checks and suspension setup. Compared with softer materials, aluminium reduces distortion during repeated assembly and disassembly.

To fit, move the tyre and any wheel hardware from the original rim onto this aluminium wheel, then confirm wheel seating and fastener alignment with your motorcycle hub. Check wheel hex size, grub screws, or locating pins on your specific Kyosho kit before final tightening. Validate concentricity by performing a low-speed bench spin or controlled test run after installation.

Use this aluminium rear wheel for accurate setup and improved mounting durability on Kyosho motorcycle builds; include wheel checks in your regular tuning routine.