Kyosho Motorcycle Front Mudguard Aluminium KM188 by GPM  [KM188]

Aluminium front mudguard for Kyosho bikes

This aftermarket RC-scale front wheel fender comes as one piece (1pcs) and is intended for use on Kyosho motorcycle platforms. It is machined from aluminium to deliver improved stiffness and resistance compared with typical plastic fenders while retaining a scale-correct finish.

Functionally the fender is mainly cosmetic and protective: it limits spray and stops light debris from reaching the wheel and lower fork components, and it provides a sturdy mounting surface for small trims or accessories. Because it is a scale accessory, expect to trial-fit and check alignment during installation.

Fitting guidance: the part mounts to existing front fork or mudguard fastenings and requires basic RC tools like hex keys and suitable screws. Check hole alignment and use thin washers or shims if needed to fine-tune the position; do not drill the original frame without verifying fit first.

Use the KM188 when you want a neater, longer-lasting front guard and an aftermarket look; always dry-fit and confirm clearances before the final screw-up.