Kyosho Motorcycle Rear Wheel Mount KM888 Aluminium Upgrade by GPM  [KM888]

Aluminium rear wheel mount for Kyosho chassis

This aluminium rear wheel holder is an RC-scale replacement part intended for Kyosho motorcycle models and is supplied as one set. It locks the rear wheel assembly in place and gives a firm mounting point for setup or track use.

Designed for Kyosho frames that accept a bolt-on rear wheel support, the holder aims to maintain axle alignment while simplifying removal and re-install of the wheel. Aluminium construction increases resistance to deformation versus stock plastic pieces, while remaining serviceable in a typical RC workshop.

Installation notes: the holder replaces the factory rear wheel mount and attaches using the bike's existing mounting points and fasteners. Confirm the original mounting geometry on your Kyosho before fitting, and use appropriate thread engagement and threadlocker where needed. Standard RC tools cover most installation tasks.

Tuning and maintenance: fit this holder when you need a fixed wheel location for setup checks, bearing swaps, or when stiffer suspension transfers more load to the mounts. As an aftermarket aluminium part it provides a straightforward, durable alternative without changing wheel geometry.