Kyosho Motorcycle Spur Gear Kit Delrin 52/53/55 DKM1000 by GPM  [DKM1000]

Kyosho Motor Cycle Delrin Wheel Gear Assembly (52T+53T+55T) - 3pcs set - GPM DKM1000
Price:
NZD$47.02
Brand:
GPM
Model:
DKM1000
GTIN:
4894538044430
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="Kyosho Motor Cycle Delrin Wheel Gear Assembly (52T+53T+55T) - 3pcs set - GPM DKM1000" title="Kyosho Motor Cycle Delrin Wheel Gear Assembly (52T+53T+55T) - 3pcs set - GPM DKM1000"

Delrin spur gear kit for Kyosho bikes

This aftermarket 3pcs gear kit is supplied as GPM model DKM1000 for use on Kyosho motorcycle platforms. The set includes three Delrin spur gears rated at 52T, 53T and 55T, packaged to allow quick replacement of worn factory plastic gears.

As the driven spur gears in the wheel assembly they mesh with the motor pinion and gearbox output. Delrin is used for its low friction and dependable wear characteristics compared with some OEM plastics, helping to reduce slop and unwanted binding during regular RC running.

Fitting advice: verify gear mesh and backlash, keep original shims and screws when possible, and confirm correct rotation before running. Because the gears are supplied separately you can mix tooth counts to alter gearing within the chassis design limits.

Specifications

  • Item Kyosho Motor Cycle Delrin Wheel Gear Assembly 3pcs set
  • Material Delrin
  • Model Number GPM DKM1000
  • Compatibility Kyosho motorcycle models

For modelers needing a straightforward, material-improved replacement, the GPM DKM1000 Delrin 3pcs set provides a simple way to refresh worn spurs and tweak drive ratio choices.

Do these gears replace the stock Kyosho spurs directly?

They are intended as direct replacements for compatible Kyosho motorcycle spurs but you should check mounting details and shaft size against your original gear before fitting.

Will Delrin handle hard use?

Delrin offers good wear resistance for typical hobby use, but extreme impacts can still damage gears; inspect after heavy runs and replace if you notice chipping.

How do I check gear mesh?

Fit the gear, install the motor pinion, then set a small amount of backlash with paper or a gauge and test free rotation by hand before powering the model.

Can I run these with stock electronics?

Yes, they work with standard RC motor and gearbox setups used on Kyosho motorcycles as long as mesh and alignment are correct.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved