Kyosho Motorcycle Swing Arm Upgrade KM014 by GPM  [KM014]

Alloy swing arm tailored to Kyosho models

This RC alloy swing arm is designed for Kyosho motorcycle kits and ships as a single-piece assembly with the matching screw and washer for direct swap-out. The component is produced from alloy and acts as the rear swing linkage member on scale motorcycles.

Use the part to replace damaged originals or to stiffen the rear end for tuning. Fitting typically requires removing the rear wheel, separating linkage pins, checking related bearings and re-torquing fasteners to the correct values. Use thread-lock where the original assembly requires it.

Tuning advice: switching to an alloy swing arm will alter flex versus OEM plastic, which can change traction and feedback. Re-check axle alignment and bearing preload after installation and run at low speed to confirm chain alignment and full suspension travel.

The KM014 alloy swing arm is a direct-fit replacement and a tuning option for Kyosho-scale bikes, ideal for routine maintenance and setup refinement.