Kyosho V One FW05-R Touring Car Engine Mount 3mm Hole KV-002 by 3Racing  [KV-002]

Kyosho FW05-R /V One R /V One RR /V One S /V One SII Engine Mount 3mm Screw Hole - 3Racing KV-002
Price:
NZD$23.82
Brand:
3Racing
Model:
KV-002
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Engine mount compatible with Kyosho V One and FW05-R

An engine mount created for Kyosho FW05-R and the V One family of touring car chassis, supplied as part KV-002. The component features the 3mm screw hole layout referenced in the product title and is suitable for replacing the engine mounting point on compatible RC touring frames.

The mount is intended to hold the engine securely while permitting minor positional tuning during setup. It is specified as a direct-fit replacement for the listed Kyosho models and intended for hobby use on model cars only.

Fitment tips: transfer original mounting bolts where practical, set engine position carefully to ensure correct clutchbell and pinion mesh, and tighten fasteners to a controlled torque to protect the 3mm holes. Additional hardware is not included unless noted by the seller.

Which specific V One variants are covered?

Listed compatibility includes V One R, V One RR, V One S and V One SII as well as the FW05-R chassis when mounted with the 3mm pattern.

Do I need new screws to fit this mount?

If your current mounting hardware is worn or mismatched you should replace it with 3mm fasteners that suit your chassis and thread engagement depth.

Can I expect a direct drop-in fit?

The part is offered as a direct-fit for the listed models but check alignment and mesh during installation to confirm fit on your specific car.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved