Kyosho SCW025 Tomahawk Carbon Servo Mount - Lightweight  [KY-SCW025]

Kyosho SCW025 - Carbon ST Servo Plate (Tomahawk)
Price:
NZD$31.86
Brand:
Kyosho
Model:
KY-SCW025
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Tomahawk Steering Upgrade with Carbon Plate

The Kyosho SCW025 Carbon Servo Plate is tailored for use with the Tomahawk and gives modelers a direct upgrade to reduce mass and increase mounting stiffness. Its carbon construction helps retain precise wheel control during aggressive driving.

Why Carbon Improves Handling

Carbon construction is prized for being both light and rigid, which benefits dynamic handling. Replacing heavier or flexible servo mounts with a carbon plate can improve throttle-to-wheel response and keep steering predictable when the load increases.

Quick Fit Guide

Fit the Kyosho SCW025 by seating the servo and tightening screws evenly to avoid stress points. After installation, check the servo horn and linkage for smooth travel and perform routine inspections to avoid loosened fasteners.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the SCW025 compatible with aftermarket servos?

The plate accepts common servo footprints used in the Tomahawk but you should confirm servo dimensions and mounting hole positions before fitting an aftermarket unit.

How much weight will I save?

Exact weight savings depend on the original part, but carbon plates typically reduce mass while increasing structural stiffness.

Any special care for the carbon finish?

Wipe the plate clean after dusty sessions and inspect for chips or cracks; light surface scratches are normal but deep damage should be addressed.

Will it affect servo calibration?

After installation check endpoint and center positions, as tighter mounting can change perceived centring slightly and may need minor trimming.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved