Kyosho SCW042-01 Wing Mount Shaft (85WC Tomahawk)  [KY-SCW042-01]

Scale wing mount shaft for the 85WC Tomahawk

The Kyosho SCW042-01 is supplied as a scale RC wing mount shaft for the 85WC Tomahawk family, intended as a replacement to maintain or restore wing attachment on compatible Tomahawk kits. It replaces shafts that have become deformed, worn, or lost through regular use.

Fitment is specific to the 85WC Tomahawk designation shown in the product name, so check your chassis code before ordering. The shaft's function is mechanical: it locates the wing, transmits clamp loads to the mount, and helps preserve alignment under aerodynamic loads at model speeds.

Installation notes for experienced builders: remove the wing from the mount, slide out the old shaft, insert the new shaft into the mount bore, and secure with the original screws or clips. Verify free movement where applicable and check endplay after tightening. Use suitable hex drivers and retainers and avoid overtightening to protect the mount from distortion.

Care and tuning advice: inspect contact points at the bearing or mount for wear after hard use and replace when excessive play shows. When altering wing angle or position, make incremental adjustments and re-check fasteners. Carry spare shafts in your parts box to minimise repair time between sessions.