Product Summary
This RC-scale replacement is supplied as a Kyosho UBW006 spare part designed for the LAZER ZX series. It serves as a direct swap for worn or damaged components during service and focuses on restoring original mounting geometry rather than altering performance characteristics.
The item is supplied as a model-specific spare intended to align with original mounting points and interfaces used on LAZER ZX components, so confirm fit before completing assembly. During installation, verify that linkages and fasteners align correctly, check for free movement, and apply thread-lock or washers where the original design calls for them.
As a service-level component, this spare helps return baseline handling so further suspension or drivetrain adjustments can be made from a known starting point. Replace only the degraded element and test the system before making tuning changes.
How to Install
Treat the part as a precision RC component: organise small parts and use the specified hex driver sizes. When refitting, use conservative torque values appropriate to model assemblies, inspect pivot joints for play, and cycle moving parts to confirm smooth action. If the component interfaces with servo, electronic speed controllers, or the motor wiring harness, ensure routing mirrors the original layout to avoid chafing.
Care Tips and Fixes
After initial running, recheck replaced components for early wear or misalignment. If steering or handling feels off, ensure all related linkages and ball bearings are correctly seated and free. For ongoing issues, consult Kyosho service diagrams or parts lists to confirm orientation and fitment.
