Kyosho UMW708-12 1.2mm Red Stabilizer Bar Circuit Upgrade  [KY-UMW708-12]

Kyosho UMW708-12 - Stabilizer Bar (1.2/Red/RB6 MID)
Price:
NZD$8.66
Brand:
Kyosho
Model:
KY-UMW708-12
GTIN:
4548565227778
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $7.88 each $1.54 or 9%
3+ $7.49 each $3.50 or 13%
Available in shop
Write a review

Dial In Stability for RB6 MID With Kyosho UMW708-12

The Kyosho UMW708-12 stabilizer bar is tailored for the RB6 MID and helps deliver more consistent handling on the circuit. At 1.2mm thick and finished in red, it aims to strike a useful balance between compliance and rigidity for controlled responses through bends.

Sharper Cornering for Club Racing

Fitting this stabilizer refines turn-in and supports cleaner exits, which is useful in tight club races. Its accurate manufacturing gives drivers predictable feedback without needing radical setup changes.

Fast Fit, Less Garage Time

This component is made to install cleanly on RB6 MID layouts so you can spend less time in the workshop. It is a practical swap for a worn bar or a straightforward tuning step when seeking improved stability.

Can I use this on a different Kyosho car?

It is intended for the RB6 MID. Other cars may require adapters or different geometry, so compatibility is not guaranteed without checking measurements.

Will the red colour affect performance?

The red finish is cosmetic. Performance comes from the bar's thickness and shape, which influence roll and balance rather than the colour itself.

Is this suitable for novices?

Yes. Installation is straightforward and the handling changes are intuitive, but beginners should make small setup changes and test gradually.

How often should I inspect the stabilizer?

Check the bar for wear and secure mounting after heavy sessions or impacts. Regular inspection helps maintain consistent handling.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved