Kyosho VZ210C FW-06 Rear Arm Set RRR/SIII  [KY-VZ210C]

Fitment guidance and practical notes

This rear suspension arm set is intended as a direct replacement for FW-06 1/10 touring chassis that use the RRR/SIII rear arrangement. The parts restore the original mounting locations and reproduce the expected rebound and roll characteristics used in many standard configurations.

When installing new arms inspect hinge pins and the contact surfaces on the rear hub for wear or damage. Clean the mount areas and confirm the arm pivots move smoothly through their full travel. Refit wheels and check rear toe and camber after installation to ensure the setup matches your prior settings.

Common uses include:

• Routine service: swap out aged arms to regain factory geometry.
• Crash repair: replace compromised arms after impacts that alter handling.
• Tuning reference: use these arms as the baseline when changing suspension geometry to keep comparisons repeatable.

Compatibility notes: built for FW-06 family chassis with the RRR/SIII rear mounting pattern. Verify your vehicle's rear hub and hinge-pin layout match before ordering.