Kyosho W0201B 5.8mm Steel Ball Set 10 Pieces for Hobby Vehicles  [KY-W0201B]

Kyosho W0201B - 5.8mm Steel Ball(10Pcs)
Price:
NZD$19.05
Brand:
Kyosho
Model:
KY-W0201B
GTIN:
4548565431151
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $15.92 each $6.27 or 16%
3+ $15.13 each $11.76 or 21%
Available in shop
Write a review

Service and Upgrade Balls for RC Linkages

The Kyosho W0201B 5.8mm steel ball set contains ten consistent, machined balls aimed at keeping hobby models in trim. Use them when renewing worn fittings or when upgrading pivot points for smoother motion.

Typical Uses Around the Model

These 5.8mm balls work well in steering assemblies, tie rod ends and certain suspension joints where a solid spherical contact is needed. They help cut slack and deliver more precise steering feedback when fitted correctly.

Compatibility Tips and Notes

Because 5.8mm is a common size, Kyosho 5.8mm Steel Balls often fit a range of kits and aftermarket parts. Verify ball seat diameter and ball cup style on your chassis to ensure proper installation and clearance.

Will these replace worn steering balls on vintage kits?

Often yes, if the original uses a 5.8mm ball. Measure the ball seat and bore to confirm compatibility before replacing older, nonstandard components.

Do these require greasing or oil?

Apply a small amount of light grease or oil to the ball seat where specified to reduce wear and prevent corrosion, but avoid excess which can attract dirt.

Can I use them in metal-on-metal joints?

Yes, they are steel so suitable for metal housings; ensure the mating surfaces are in good condition to avoid accelerated wear.

How do I check for correct fit after installation?

After fitting, cycle the suspension and steering to confirm smooth movement with no binding or excessive play, and re-tighten mounting points if needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved