LaTrax SST Offset Wheel Hex Adapter +2mm with Brake Disk SST010AD2MM by GPM  [SST010AD2MM]

Upgrade hub hexes for LaTrax SST

This aluminium wheel hex adapter set is an aftermarket component for TRAXXAS LaTrax SST platforms, supplying a +2mm offset and a decorative brake disk on each hub. Four pieces are supplied to replace the original plastic hexes and increase mounting stiffness and wheel location accuracy for scale RC builds.

The small +2mm shift can be handy when adjusting track width or avoiding body and suspension interference on LaTrax SST and Teton builds. Aluminium construction reduces the risk of hex distortion under typical hobby use while preserving the standard hex interface so compatible wheels remain easy to fit.

Installation is normally a simple swap of the factory hexes, reusing existing fixings where suitable; the brake disk is intended for scale realism only. As with any hub change, inspect threads and fasteners after initial runs to ensure secure wheel mounting.

If you want a tougher wheel mounting and a modest offset change on LaTrax SST or Teton kits, this aluminium hex adapter kit gives a reliable replacement with a neat brake-disk aesthetic and simple installation.