LAZER ZX7.5 Gear Diff Shaft (2pcs) - Kyosho LA402-04  [KY-LA402-04]

Kyosho LA402-04 - Gear Diff. Shaft (2pcs/ZX7.5)
Price:
NZD$19.47
Brand:
Kyosho
Model:
KY-LA402-04
GTIN:
4548565524013
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $16.45 each $6.03 or 15%
3+ $15.63 each $11.52 or 20%
Write a review

LAZER ZX7.5 Differential Shaft Details

These two gear diff shafts are intended for use in the LAZER ZX7.5 differential assembly and are offered as a matched pair. They replace worn shafts that can cause excess play and inconsistent diff response during running.

Fitment is restricted to LAZER ZX7.5 variants using the same internal gear diff layout, so confirm compatibility with your chassis before fitting. The pack provides two pcs to service both sides of a standard gear differential.

Installation guidance: treat this as a scale RC maintenance item. During a diff service, remove the unit, clean the internals, inspect the gears and bearings, then install the new shafts with correct spacing and grease. Proper seating prevents binding and supports reliable operation.

Performance note: fresh shafts reduce lateral play and help the diff engage more predictably. For best results, inspect spur and pinion mesh and bearing condition at the same service interval.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Are these shafts sold as singles or a set?

Kyosho LA402-04 is supplied as a two-piece set, providing both diff shafts needed for a standard gear differential in LAZER ZX7.5 models.

What should I check to ensure correct fit?

Verify your LAZER ZX7.5 uses the same internal gear diff layout and compare the new shaft dimensions to originals. Confirm clearance and seating before completing assembly.

Any lubrication advice when installing?

Use an appropriate diff grease on the gear teeth and reapply light lubrication where shafts contact bearings. Recheck rotation and endplay after greasing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved