Left Aluminium Front Bulkhead for GTX 2026 Flat Chassis - XRAY 352017  [XR-352017]

XRAY 352017 - GT Aluminium Front Bulkhead - Left - Flat Chassis - Swiss 7075 T6
Price:
NZD$77.19
Brand:
XRAY
Model:
XR-352017
Condition:
Brand New
Write a review

Left Aluminium Bulkhead for GTX 2026

This left front aluminium bulkhead is built for flat-chassis setups and cars running the GTX 2026 layout. Crafted from Swiss 7075 T6 material, it is intended to stiffen the front section without altering planned chassis dimensions.

The component keeps the original suspension pickup locations so geometry stays consistent lap after lap, and the reduced flex improves predictability during cornering and under acceleration. Carefully chamfered edges and a machined finish assist in lowering stress at bolt points.

Installation on compatible flat-chassis vehicles is simple: attach the unit to the left-front mounting points and secure with the car's standard fasteners. Verify alignment and torque values after fitting; use regular tuning changes to adjust roll center or camber rather than modifying the bulkhead itself.

Specifications

  • Item XRAY GT Aluminium Front Bulkhead - Left
  • Material Swiss 7075 T6 aluminum
  • Model Number 352017
  • Compatibility Flat chassis, GTX 2026

Designed as a direct left-front replacement for flat-chassis GTX 2026 vehicles, this aluminium bulkhead aims to improve front-end rigidity and drivetrain support while preserving suspension geometry for precise tuning.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this bulkhead more durable than plastic options?

Yes. Swiss 7075 T6 aluminium offers superior stiffness and wear resistance versus typical plastics, improving long term durability in high load areas.

Will I need to change my setup after fitting this?

Most users find the suspension geometry is unchanged, so only minor setup refinements are needed if any. Use standard tuning steps to adjust handling characteristics.

Are special bolts required to install this part?

Usually no. The bulkhead is designed to use the vehicle's existing left-front fasteners, though check that screws are in good condition and torqued correctly.

How does this part influence handling consistency?

By cutting chassis flex at the front, the aluminium bulkhead helps keep suspension geometry stable under load, which improves repeatability during tuning and track runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved