Lepton SZM Service Damper Rubber for HI0304011 by Hirobo  [HI0304011]

Damper Rubber for Lepton SZM

This damper rubber is built for the Hirobo Lepton SZM and acts as a direct service replacement for hardened or worn damping elements within the helicopter shock units. It is made for model helicopter use to preserve intended damping during launch, hover and landing phases of RC operation.

The rubber element sets rebound and initial compression behaviour inside the damper tube; fitting a new piece brings back responsiveness and consistent feel. It is supplied as a service item for routine maintenance or when fine tuning damping; changes in rubber condition will alter the perceived damping response.

Installation depends on the specific damper assembly used on the Lepton SZM but is typically simple. Fit matching replacements, check adjacent seals and shafts for wear, and reassemble following the damper assembly's standard procedure. No specialist equipment is required beyond common RC tools.