LiFe LF2200-6.6V Racing Pack and LF-6.6V Charger - Tamiya 55104  [55104]

Tamiya 55104 - LiFe LF2200-6.6V Racing Battery Pack & LF-6.6V Battery DC Charger
Price:
NZD$378.63
Brand:
Tamiya
Model:
55104
Write a review

Overview of the LF2200 pack and charger

This set pairs the LF2200-6.6V LiFe racing battery with the LF-6.6V DC charger to offer a compact charging solution for electric RC models. Both components are intended for hobby use and standard RC workflows.

The LF-6.6V charger needs a separate, stable DC source when converting from AC; check the charger manual for the correct input range and capacity before connecting. Observe common-sense safety: charge on a fire-resistant surface, keep an eye on the process, and do not leave packs unattended during charging.

Used together, the pack and charger promote steady voltage delivery and controlled charging cycles, which helps maintain consistent motor and ESC behavior during practice sessions. Use the charger to preserve LiFe cell health and to stabilise voltage between battery swaps.

Technical details

  • Item Tamiya LiFe LF2200-6.6V Racing Battery Pack and LF-6.6V Battery DC Charger set
  • Material LiFe chemistry battery, electronic DC charger
  • Model Number 55104
  • Compatibility For RC electric models and LiFe-compatible charging systems

If you want to work with LiFe chemistry in your RC models, this matched pack and DC charger provide the essentials; verify power source compatibility for the charger and follow recommended charging routines for safe, repeatable operation.

How should I power the LF-6.6V charger from my workshop supply?

Use a regulated DC supply that matches the charger's specified input voltage and can provide sufficient current. Avoid cheap, unstable sources and confirm polarity before connecting the charger.

Can I store the LF2200 pack long term in the model?

For long-term storage, partially charge the pack to the recommended storage state and keep it in a cool, dry place. Remove the battery from the model if it will not be used for extended periods to reduce drain and stress.

What connector and fit checks should I perform?

Before installation, verify the pack's connector type matches your ESC and secure the pack so it cannot move during runs. Check that wires are routed away from moving parts and heat sources.

Does the charger balance individual cells?

This charger is intended for charging LiFe chemistry as a matched pack. Consult the charger documentation regarding balance functions and follow the manufacturer's guidance for cell maintenance.

How can I check pack health before a run?

Measure the pack voltage with a meter and confirm expected voltage under light load. If the voltage seems low or unstable, recharge using the LF-6.6V charger and re-test before installing the pack for a session.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved