LOSI 5IVE-TE/5IVE-TG Front & Rear CVD Shafts 152mm 4140 Steel - 5T3/152S by GPM  [5T3/152S]

LOSI 5IVE-TE 3.0 1/5 Desert Truck 4140 Steel Front / Rear CVD Drive Shafts 152mm - GPM 5T3/152S
Price:
NZD$97.63
Brand:
GPM
Model:
5T3/152S
Condition:
Brand New
Write a review

Reinforced CVD drives for LOSI 1/5 5IVE trucks

This aftermarket assembly swaps in place of the stock LOS-3705 and LOS-3674 front and rear shafts with a 4140 steel constant-velocity design tailored for LOSI 1/5 5IVE-TE and 5IVE-TG vehicles. The specified pin center-to-center length is 152mm and the dogbone section is beefed up to reduce bending under load. The original locating pin detail has been removed to deliver a simplified, stronger joint.

Intended as direct-fit replacements for the listed LOSI models, the set requires checking alignment and driveline angles during fitment to avoid binding. Confirm hub set screw torque after initial running. As the pack often covers a single axle arrangement for some builders, two packs may be required for a complete front and rear upgrade.

What the kit contains

  • Front/Rear CVD Drive Shafts - 2 pcs
  • Pins 5x23.5 - 2 pcs
  • Set Screws 5x6 - 2 pcs

OEM Part References

LOS-3705, LOS-3674

Fits these LOSI models

  • LOSI 1/5 5IVE-TE 3.0 Electric 4WD Desert Truck RTR-LOS05022
  • LOSI 1/5 5IVE-TG 3.0 Gas 4WD Desert Truck RTR-LOS05025

This 4140 steel CVD set provides a direct-fit strengthening alternative for LOSI 5IVE-TE and 5IVE-TG 1/5 desert trucks where greater drivetrain durability is wanted; follow normal installation checks and break-in guidance after fitting.

Yes. The components are manufactured to serve as direct-fit replacements for the OEM LOS-3705 and LOS-3674 on the compatible LOSI models listed above.
The shafts are made from 4140 steel, chosen for improved tensile strength and wear resistance; the design focuses on robustness rather than weight savings.
Confirm the pin center-to-pin center measurement of 152mm for your hubs. The kit is specified at 152mm and includes a reinforced dogbone section for stronger load transfer.
No. The locating pin was removed to lower stress concentrations and create a cleaner joint interface, which in turn enhances overall durability in this design approach.
For full front and rear replacement most users will buy two packs. Depending on your assembly method one pack may only be sufficient for a single axle swap.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved