Losi Super Baja SB014L Ball and Screw Maintenance Pack SB014L/ACC by GPM  [SB014L/ACC]

Team Losi SUPER BAJA 2 Balls And 6 Screws set For SB014L - GPM SB014L/ACC
Price:
NZD$13.24
Brand:
GPM
Model:
SB014L/ACC
GTIN:
4894538304756
Condition:
Brand New
Write a review

Replacement components for SB014L linkage

This maintenance pack is produced for Team Losi SUPER BAJA SB014L as a direct spare for worn linkage hardware. Identified by model SB014L/ACC, the set supplies the small ball ends and mounting screws commonly replaced after extended running.

Purpose: upkeep and minor tuning. Swapping out fatigued balls and fasteners brings back reliable movement and tight fitment at pivot points without modifying the chassis setup or geometry. The kit is small and intended for regular service intervals.

Installation tips: confirm screw thread fit and ensure ball seating before final tightening, only replace with like-sized parts, and exercise the steering and suspension travel after installation to check for binding. This description is specific to RC model components only.

How do I know these will fit my SB014L?

Compare the old ball diameter and screw length to the replacements; the SB014L/ACC set is made to match the original small-diameter linkage hardware.

Can I use these on other Losi models?

They may fit other models with similar linkage dimensions, but always verify size and thread type before installing on a different chassis.

How often should I replace these parts?

Replace balls and screws when you notice play, corrosion, or wear affecting movement. Frequency depends on use, terrain and maintenance habits.

Any special tools required for fitting?

Standard hobby screwdrivers and pliers are sufficient; use a torque-limited driver or careful hand tightening to avoid stripping small threads.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved