Lower Rear Suspension Arm (Graphite) for Serpent Medius X26 - O-SPP007R by Factory Pro  [FP-O-SPP007R]

Rear lower arm, graphite option for Medius X26

This aftermarket RC lower rear suspension arm is manufactured for the Serpent Medius X26 chassis and supplied as 1 pcs in graphite. It serves as a replacement for worn rear lower arms and as a stiffer-material option when refining chassis behaviour during setup.

Functionally focused for mechanics and tuners, the arm helps restore correct mounting geometry and can lessen unwanted flex seen in aged plastic parts, aiding alignment stability through repeated runs. Fit it when replacing damaged components or when experimenting with material changes in the rear suspension layout.

Installation guidance: the part matches the rear lower arm position on Serpent Medius X26 chassis. Remove the existing arm per your chassis instructions, check hinge pin and ball stud clearances after fitting, and carry out a short alignment check on level ground before normal use. Intended for RC-scale applications only.